Frequency Counter using PIC16C5x -
Application Note Published 26-Aug-97. . . [Microchip]
GPS-based universal clock
generator - For your microwave frequency counter you don't need a Cesium-beam clock inside your lab
when there are at least five flying at 20000Km above you. Locking on the 10KHz output of a Rockwell GPS module we
built a 10ppb accurate frequency reference. . . . [Andrea (IW9HJV) and Johnny (IW9ARO)]
Laser Used As
Vehicular Traffic Counter - This is an illustration how a laser could be used to count traffic and
measure the speed of each car passing through the sensor area . . . [Circuit by David Johnson P.E., 01/07/07]
Line Powered
60hz Clock Generator - This circuit is connected to the 120vac power line and transfers 60Hz clock
pulses to a logic circuit. The optoisolator used provides 5000 volts of isolation between the power line and the
logic side of the circuit . . . [Circuit by Dave Johnson P.E., 02/23/99]
Microcontroller makes effective
frequency counter - 11/23/00 EDN Design Idea Figure 1 shows an efficient and cost-effective
frequency counter using an Atmel 89C2051 mC (Reference 1). The design can use any mC of the 8051 family. The
circuit counts frequency and sends the count to a PC via the serial port. . . [by Fazal Pathan, Physical
Research Laboratory Ahmedabad, India]
One GHz Frequency Counter -
This simple counter is useful for frequency measurements of various wireless equipments, especially transmitters,
receivers and signal generators in VHF/UHF band. . .
PIC Frequency Counter -
Programmable frequency meter with PIC16F84 and UPB1505 prescaler. . .
Transcendent Frequency Counter - This is a
top quality project designed to obtain maximum performance. The hardware and software has been pushed to reach
the frontier of technology. The transcendent is not only a frequency counter, it is a corner stone in your
successfully constructions. . . . [can't find owner's name on website]
Transition Counter Gauges Thermal
Stability - 01/04/96 EDN Design Idea The transition count of Figure 1is an easy way to determine if
the temperature in a heater is stable. The stable state maximizes the transitions. This circuit works like a
digital filter with controlled frequencies and is simpler. . . [by Jose Luis Arce,Tecnosuma Havana, Cuba Jose
Luis Arce,Tecnosuma Havana, Cuba] |