Remote Touch
Switch Sensor: This tiny 3/8 inch square module is designed to be
wired to a metal touch button or to a metal touch plate. Powered by a special signal from
an Exciter/Interface module, the sensors can be separated from the control module by
several hundred feet. These sensors are ideal for applications where multiple and widely
separated touch buttons need to be monitored. The sensors can also be connected in
parallel, forming an "or" logic function. Such a technique allows multiple
switches in several locations to activate a single control function.
Exciter/Interface
Module: This module is designed to be used with up to 24 touch sensors. It
supplies the remote touch sensors with a special signal and processes the outputs from the
touch sensors. It operates in a momentary switch operation. Each module has 24 inputs and
24 outputs. All the outputs are standard TTL logic levels which can source or sink
current. The outputs can be programmed for a normally high or a normally low. A single
programming pin selects the polarity. The exciter/interface module can be installed
several hundred feet from the touch sensors it supports.
24 Button
Touch Switch Control Module: This module is designed to be used with up to
24 touch buttons or touch plates. It is ideal when the touch buttons or plates can be
clustered around and near the control module. The separation distance between the touch
buttons and the modules should not exceed 6 feet. As in the Exciter/Interface module the
Control module has 24 inputs and 24 outputs. All the outputs are TTL levels and can be
programmed for a normally high or a normally low. A single programming pin selects the
desired polarity. |